An incoming SETUP message needs to reject the invalid ie 0x01 on switches
other than 4ESS, 5ESS, NI2, and DMS-100.
LIBPRI-74 #close
Reported by: Richard Mudgett
git-svn-id: https://origsvn.digium.com/svn/libpri/branches/1.4@2333 2fbb986a-6c06-0410-b554-c9c1f0a7f128
Added support to the libpri API to control the inband audio available
progress indication ie on the SETUP_ACKNOWLEDGE message.
* Added the progress indication ie progressmask value to the struct
pri_event_setup_ack so the PRI_EVENT_SETUP_ACK event can indicate when a
SETUP_ACKNOWLEDGE comes in with inband audio (ie dialtone).
* Added pri_setup_ack() so when the SETUP_ACKNOWLEDGE message is sent it
can indicate if inband audio is present (ie dialtone).
This patch and a corresponding change in Asterisk work together to allow
Asterisk to control the inband audio available progress indication ie on
the SETUP_ACKNOWLEDGE message when dialtone is present.
AST-1338 #close
Reported by: Tyler Stewart
Review: https://reviewboard.asterisk.org/r/3520/
git-svn-id: https://origsvn.digium.com/svn/libpri/branches/1.4@2320 2fbb986a-6c06-0410-b554-c9c1f0a7f128
* Fixed stopping T303 too early on a NT PTMP broadcast SETUP call if a
subcall just receives a RELEASE_COMPLETE(busy).
* Fixed a valgrind reported invalid read/write when hanging up a NT PTMP
broadcast SETUP call.
JIRA LIBPRI-32
JIRA SWP-2548
git-svn-id: https://origsvn.digium.com/svn/libpri/branches/1.4@2238 2fbb986a-6c06-0410-b554-c9c1f0a7f128
This completes the layer 2 link and Q.931 call control restructuring.
Some code is now simplified since there is only one D channel control
structure and the amount of allocated memory is reduced.
git-svn-id: https://origsvn.digium.com/svn/libpri/branches/1.4@2077 2fbb986a-6c06-0410-b554-c9c1f0a7f128
This is in anticipation of extracting a layer 2 link structure out of
struct pri.
Also completes fixing timer value access for the rest of libpri. The
timer access must always be on the D channel control structure (Master).
May have fixed some events from timeouts not being passed to the upper
layer. The timeout events must always be on the D channel control
structure (Master).
git-svn-id: https://origsvn.digium.com/svn/libpri/branches/1.4@2070 2fbb986a-6c06-0410-b554-c9c1f0a7f128
The DL-ESTABLISH confirm event was not passed from Q.921 to Q.931 so Q.931
never cancelled the T309 timer.
Refactored q931_dl_tei_removal() and q931_dl_indication() into
q931_dl_event() to allow the DL-ESTABLISH confirm/indication and
DL-RELEASE confirm/indication events to be passed to Q.931.
git-svn-id: https://origsvn.digium.com/svn/libpri/branches/1.4@1991 2fbb986a-6c06-0410-b554-c9c1f0a7f128
If the connection to the terminal is lost while there are open channels
on the interface, red alarm is reported, but the open channels are never
cleared. Additionally, if you manually try to channel request hangup,
Asterisk crashes.
For PTMP, the T309 processing was not searching the call pool on the
master control record. Additionally, for NT PTMP, the timeout events were
not passed to the upper layer because the events were not put on the
master control record where timer processing expects them.
(closes issue #17865)
Reported by: wimpy
Patches:
issue17865_v1.4.patch uploaded by rmudgett (license 664)
Tested by: rmudgett, wimpy
git-svn-id: https://origsvn.digium.com/svn/libpri/branches/1.4@1982 2fbb986a-6c06-0410-b554-c9c1f0a7f128
Call Completion Supplementary Service (CCSS) added for the following
switch types: ETSI PTMP, ETSI PTP, Q.SIG.
Specifications:
ETS 300 359 CCBS for PTMP and PTP
ETS 301 065 CCNR for PTMP and PTP
ECMA-186 Call Completion for Q.SIG
Several support services were added to support CC:
Dummy Call Reference.
Q.931 REGISTER message.
Dynamic expansion of the number of available timers (up to 8192).
Enhanced facility message handling.
Current implementation limitations preclude the following:
CC service retention is not supported.
Q.SIG path reservation is not supported.
(closes issue #14292)
Reported by: tomaso
Tested by: rmudgett
JIRA SWP-1493
Review: https://reviewboard.asterisk.org/r/522/
git-svn-id: https://origsvn.digium.com/svn/libpri/branches/1.4@1714 2fbb986a-6c06-0410-b554-c9c1f0a7f128
Since the TE side can pick CR values independently, the TE CR needs to be
qualified by TEI to distinguish CR values from other devices. Without
doing this, multiple phones on the BRI line will have intermittent call
failures.
JIRA LIBPRI-30
Also eliminated some wierdness in q931_status() and several places where
it is called.
git-svn-id: https://origsvn.digium.com/svn/libpri/branches/1.4@1630 2fbb986a-6c06-0410-b554-c9c1f0a7f128
* Added support for BRI PTMP NT mode. (Overlap dialing NT -> TE not supported.)
* Added handling of received HOLD/RETRIEVE messages and the optional ability
to transfer a held call on disconnect similar to an analog phone.
* Added CallRerouting/CallDeflection support for Q.SIG, ETSI PTP, ETSI PTMP.
Will reroute/deflect an outgoing call when receive the message.
Can use the DAHDISendCallreroutingFacility to send the message for the
supported switches.
* Added ability to send/receive keypad digits in the SETUP message.
Send keypad digits in SETUP message: Dial(DAHDI/g1[/K<keypad_digits>][/extension])
Access any received keypad digits in SETUP message by: ${CHANNEL(keypad_digits)}
(closes issue #15048)
Tested by: rmudgett, mattf
git-svn-id: https://origsvn.digium.com/svn/libpri/branches/1.4@1242 2fbb986a-6c06-0410-b554-c9c1f0a7f128
The Telecom Specs in NZ suggests that SUB ADDRESS is always on, so doing
"desk to desk" between offices each with an asterisk box over the ISDN
should then be possible, without a whole load of DDI numbers required.
(closes issue #15604)
Reported by: alecdavis
Patches:
libpri_subaddr_trunk.diff11.txt uploaded by alecdavis (license 585)
Some minor modificatons were made.
Tested by: alecdavis, rmudgett
Review: https://reviewboard.asterisk.org/r/406/
git-svn-id: https://origsvn.digium.com/svn/libpri/branches/1.4@1230 2fbb986a-6c06-0410-b554-c9c1f0a7f128
* Removed unnecessary Q931_IE_CONNECTED_NUM ie from setup_ack_ies[].
* Added internal state Q931_CALL_STATE_NOT_SET to Q.931 state enum.
* Made q931_is_ptmp() take a const pointer.
* pri_facility.c: Some preparations for subaddressing.
* pri.c: Eliminate use of a magic number.
git-svn-id: https://origsvn.digium.com/svn/libpri/branches/1.4@1177 2fbb986a-6c06-0410-b554-c9c1f0a7f128
This set of changes integrates SERVICE message support for the
'national' switchtype. The 'national' switchtype uses the 0x43
protocol discriminator. The 'national' SERVICE/SERVICE ACKNOWLEDGE
and AT&T SERVICE/SERVICE ACKNOWLEDGE message values are opposite
of each other. This is handled by first determining which
protocol discriminator is in use, then responding with the appropriate
SERVICE ACKNOWLEDGE value. AT&T SERVICE messages use the
0x3 protocol discriminator.
(closes issue #15803)
Reported by: dhubbard
Review: https://reviewboard.asterisk.org/r/347/
git-svn-id: https://origsvn.digium.com/svn/libpri/branches/1.4@1072 2fbb986a-6c06-0410-b554-c9c1f0a7f128
These API calls do not modify the string supplied, and should not be allowed to modify it, so this patch adds a 'const' qualifier to that argument to allow the compiler to enforce this restriction (and allow callers of the API that already have a 'const' pointer to be able to pass it to this API).
git-svn-id: https://origsvn.digium.com/svn/libpri/branches/1.4@798 2fbb986a-6c06-0410-b554-c9c1f0a7f128
This adds support for two new message types: Service and Service Acknowledge.
When a channel receives a service message it will either take the channel in
or out of service and then send a service acknowledgment. Although not
enforced here (enforced in chan_dahdi), the service messages are only supported
with switch types 4ess/5ess. The required Asterisk changes will be coming next.
(issue #3450)
Reported by: cmaj
git-svn-id: https://origsvn.digium.com/svn/libpri/branches/1.4@732 2fbb986a-6c06-0410-b554-c9c1f0a7f128
event for Q931_IE_KEYPAD_FACILITY and all of the various Q.SIG functions,
2BCT on 5ESS, and a few other random changes
git-svn-id: https://origsvn.digium.com/svn/libpri/trunk@195 2fbb986a-6c06-0410-b554-c9c1f0a7f128
Richard Mudgett