USB_RECOV.hex is an extra firmware that may be useful for recovering
from certain Astribank hardware faults in some scenarios. This adds
support for either loading it manually
('/usr/share/dahdi/xpp_fxloader recover-sb') or through udev, *if*
the required udev rules were set on the system.
Signed-off-by: Tzafrir Cohen <tzafrir.cohen@xorcom.com>
git-svn-id: http://svn.astersk.org/svn/dahdi/tools/trunk@10349 17933a7a-c749-41c5-a318-cba88f637d49
This introduces support for loading multiple firmwares in parallel also
for the case of a manual load. This is anyway the case for an automatic
load from udev.
* libusb needs to scan the bus all too often. This causes occasional
failures for opening devices.
* Thus introduce a semaphore to serialize uses of libusb.
E-Main-3 firmware differs by a different value of bcdDevice:
* Read this from the sysfs devices tree.
* Fall back to lsusb -v (much slower) is sysfs not available.
Signed-off-by: Tzafrir Cohen <tzafrir.cohen@xorcom.com>
git-svn-id: http://svn.astersk.org/svn/dahdi/tools/trunk@10348 17933a7a-c749-41c5-a318-cba88f637d49
Echo Cancellation firmware is loaded by xpp/stribank_hexload
(Using the oct612x code).
* astribank_hexload: options -O/-o/-A for handling the Octasic echo
cancellation firmware.
* astribank_tool: report that.
* xpp_fxloader: Run astribank_hexload, if needed.
* dahdi_perl: The EC module is an extra XPD, but not a "telephony device"
and hence not a span. Deal with that.
* waitfor_xpds: may need to wait a bit longer for firmware loading.
Signed-off-by: Tzafrir Cohen <tzafrir.cohen@xorcom.com>
git-svn-id: http://svn.astersk.org/svn/dahdi/tools/trunk@10032 17933a7a-c749-41c5-a318-cba88f637d49
* Move most of the USB access code from xpp/ to xpp/xtalk/ .
* astribank_tool and such tools can now use a shorter -D mmm/nnn rather
than a full path.
Signed-off-by: Oron Peled <oron.peled@xorcom.com>
Acked-by: Tzafrir Cohen <tzafrir.cohen@xorcom.com>
git-svn-id: http://svn.astersk.org/svn/dahdi/tools/trunk@9825 17933a7a-c749-41c5-a318-cba88f637d49
When called from udev to load the FPGA firmware, make sure that this is
not the event generated for the first end-point of the existing two, as
we need to talk with the second one.
This is probably better done in the udev rules, but will be slightly
more complicated to apply only to the FPGA loading and not to USB
firmware loading.
git-svn-id: http://svn.astersk.org/svn/dahdi/tools/trunk@9482 17933a7a-c749-41c5-a318-cba88f637d49
