This is a rework of the audio join procedure whithout the explict listen
only separation in mind. It's supposed to be used in conjunction with
the transparent listen only feature so that the distinction between
modes is seamless with minimal server-side impact. An abridged list of
changes:
- Let the user pick no input device when joining microphone while
allowing them to set an input device on the fly later on
- Give the user the option to join audio with no input device whenever
we fail to obtain input devices, with the option to try re-enabling
them on the fly later on
- Add the option to open the audio settings modal (echo test et al)
via the in-call device selection chevron
- Rework the SFU audio bridge and its services to support
adding/removing tracks on the fly without renegotiation
- Rework the SFU audio bridge and its services to support a new peer
role called "passive-sendrecv". That role is used by dupled peers
that have no active input source on start, but might have one later
on.
- Remove stale PermissionsOverlay component from the audio modal
- Rework how permission errors are detected using the Permissions API
- Rework the local echo test so that it uses a separate media tag
rather than the remote
- Add new, separate dialplans that mute/hold FreeSWITCH channels on
hold based on UA strings. This is orchestrated server-side via
webrtc-sfu and akka-apps. The basic difference here is that channels
now join in their desired state rather than waiting for client side
observers to sync the state up. It also mitigates transparent listen
only performance edge cases on multiple audio channels joining at
the same time.
The old, decoupled listen only mode is still present in code while we
validate this new approach. To test this, transparentListenOnly
must be enabled and listen only mode must be disable on audio join so
that the user skips straight through microphone join.
There are some situations where previously set deviceIds (
local/session storage) may become stale. This causes an unexpected
behavior where audio is temporarily borked until the user clears their
local storage.
This issue has been seen more recently on Safari endpoints when switching
back-and-forth breakout rooms in environments running under iframes.
Also seen randomly on endpoints with virtual input devices.
This centralizes audio gUM calling into a single method that retries the
gUM procedure without pre-set deviceIds only if the initial call fails
due with an OverconstrainedError - hopefully circumventing the issue.
There's no rollback procedure in case a device switch fails right now,
nor does the code entrypoints that call the switching procedures wait
for resolution or failure before marking the new device as chosen. That
may cause inconsistent states in a couple of ways:
- No rollback: switch fails, audio is still on but no actual
microphone input is being transmitted
- Not waiting for resolutions: inconsistent chosen devices on failures
Device switching errors are also not surfaced to the end user
This commit:
- Adds device rollback and proper resolution/failure response
awaits to try and make the state a bit more consistent.
- Centralizes the input device switching code to be reused between
different bridges
- Centralizes device ID state management in audio-manager to try and
mantain them a bit more consistent across the board
- Surface device switching failures to the end user
- Guarantee device IDs are set to the session storage on all
appropriate scenarios
